Menu

Lighting

How to burn a turf incense sod

A turf incense sod smouldering on a slate on a cottage windowsill, rain on the window
Illustration. One sod on a slate, a mug of tea, a wet day outside.

The shop’s method is short. One sod, the slate, a flame, then a smoulder. Do it on a heat-proof surface, in a room with some air, and away from anything that can catch.

  1. Set the reclaimed slate on a steady, heat-resistant surface. The pads are there to keep the slate off the table. If you have the cottage, it sits on the slate or on another heat-proof base, over the sod.
  2. Place one sod on the slate. One is enough. The pieces are small, about 3–5 cm for a full sod.
  3. Hold a lighter or a match on the sod until it glows. The shop says a sustained flame of about 5–10 seconds usually does it.
  4. Blow the flame out. Let the sod smoulder. A full sod is listed at about 35–45 minutes.
  5. Leave it until it is cold. Then tip the ash into a non-flammable bin. Do not wrap a warm piece in paper.

If it will not take

Damp is the reason the shop gives. Turf incense absorbs moisture if the room is humid or the packet has been left open. Dry the piece in a low oven for a few minutes, let it cool enough to handle, and try the flame again. After that, keep the pack sealed and off a windowsill.

Smoke, alarms, and small rooms

You should see a light smoke and smell the peat. The shop’s FAQ says an alarm goes off when the burner is placed directly under it, and not in ordinary use. Still, do not sit the slate in a tight hall under the only alarm, and crack a window if the room is small. Flats and houses with no chimney are covered in no-chimney homes.

What not to do

New to it? The starter set is the slate plus seven sods. Already have the slate? Use a refill.